¹V. Lashkaryov Institute of Semiconductor Physics, National Academy of Sciences of Ukraine
41, prosp. Nauky, 03680 Kyiv, Ukraine
E-mail: demid.pekur@gmail.com,
¹National Technical University of Ukraine “Igor Sikorsky Kyiv Polytechnic Institute”
37, prosp. Beresteysky, 03056 Kyiv, Ukraine
E-mail: y.nikolaenko@kpi.ua

Abstract. Considered in this paper are the parameters and characteristics of the developed highly efficient electronic control systems for powerful LED modules (drivers), built on the basis of a single-stage flyback converter with a nominal power close to 200 W. The results of experimental tests show that, at the nominal load, the minimum efficiency of the developed driver reaches 88.2% with the power factor above 0.97 and the coefficient of total harmonic current distortion close to 23.4%. With the maximum value of the efficiency factor of the developed system 90.3% and the supply voltage 240 V, the power factor is higher than 0.99, and the total harmonic current distortion is 3.6%. The values of current harmonics of the driver do not exceed the maximum allowable values defined by the current standards. Used driver construction topology enabled to reduce the cost of the final product due to the unification of the component base, which increases the availability and manufacturability of the design. The use of a modern element base made it possible to ensure the deviation of the output current from the set one by no more than 1% over the whole range of the operating voltage of the supply (180…250 V), which allows using the developed driver in intelligent lighting systems and lighting systems with a combined power supply.

Keywords:power LED, LED driver, high power factor, high efficiency, total harmonic current distortion, intelligent light system.

Full Text (PDF)

Back to Volume 26 N2